Fast, complete, efficient waste disposal

• Dual chamber combustion.

• Chambers insulated and lined with high temperature refractory.

• Programmable digital temperature controls and chart recorder.

• Modulating control for fuel and air lowers fuel consumption.

• Preheat and secondary chamber temperatures up to 1200° C and two (2) second retention

The Benefits of Incineration . . .

The P60 range of incinerators are designed to burn disposables that can and should be destroyed on-site. These wastes include infectious and contaminated "red bag," surgical dressings, plastic test devices and other wastes. If your 100 to 400 bed hospital is paying a high fee to haul these waste materials to a disposal site, now is the time to consider on-site incineration.

On-site incineration is a thorough, fast, and cost effective way to dispose of medical waste. Inciner8’s P60-M2 incinerators are engineered to meet strict air emission regulations with dual chamber combustion. Our modular design is easy to install.

Medical Incinerator Models

P60-4GLP-M2 Propane fired incineration system complete with two burners, secondary chamber, stack, timer and digital temperature control, with two second retention.

P60-4GN-M2 Natural gas fired incineration system complete with two burners, secondary chamber, stack, timer and digital temperature control, with two second retention.

Charging Rate

Up to 110kgs per hour of typical red bag waste, dependent upon density, BTU value of the waste, and subject to reloading regulations. Additional time may be required for burnout of final charge.

 Specifications Summary

Primary chamber dimensions (external)		1.28m W x 1.88m L x 1.67m H
Primary chamber volume		1.65m3
Secondary chamber dimensions (external)	Upper section	2.40m L x 1.50m D
	Lower section	1.55m L x 1.05m D
Secondary chamber volume		3.88m3
Secondary preheat temperature		900 - 1200° C
Secondary operating temperature		900 - 1200° C
Secondary retention time		2 seconds
Height to top of secondary chamber		4.94 m
Automatic loader/hopper volume		.42m3
Loader ram		Pneumatically powered (Optional hydraulics)
Ash door opening		47.5cm  x 90cm
Stack dimensions		60cm O.D. x 45cm I.D. x 122cm L
Insulation		2.5cm mineral wool
Refractory		Primary chamber 10cm Secondary chamber 8cm
Overall dimensions		5.70m L x 3.0m W x 9.9m H
Total weight		10900kgs. approx.
Suggested pad size		6.0m W x 9.0 L x 15cm thick
Gas service		4,400,000 BTUH
Electrical service		220V 50 Hz. 30 amp
Water service		3.1 litres pm @ 60 psi
Compressed air		9.5 cfm @ 100 psi, with 110 litre reserve